Sometimes, infill is visible through the surfaces of a print. Even when the plastic is opaque enough not to show the infill by translucence, the infill pattern can sometimes be seen in the form of a slight structure or texture that it imparts to the outside of a print. This can occur two separate ways: for the top and the sides of a print. Read More
There are two main opposing types of errors that can produce poor corners: ringing and corner swell. To achieve high-quality corners, certain parameters must be matched to the printer’s physical characteristics, and they must be balanced to avoid falling into either of these errors. Before reading this article, check out the explanations for Ringing and Corner Swell. Read More